50 / BOX

Corner Bead

Provides a straight arris that will not easily crack and reinforces the render where it is most required. The expanded mesh wings of angle bead provide an excellent mechanical key for the render. 45mm wing. Available Galvanised, Novaplas coated or Stainless Steel.
3m long

50 / BOX

Stop Bead

Are used wherever a finished render edge is required. Available Galvanised, Novaplas coated or Stainless steel.
1Omm, 13mm, 16mm and 19mm thick.
3m long

50 / BOX

Bellcast Bead

Designed to create a horizontal finished edge at the junction of render and facing bricks. Available Galvanised, Novaplas coated or Stainless Steel. 16mm.
3m long

50 / BOX

Movement Bead

Offer a solution to the problem of thermal movement in the render. Formed from two stop beads and a duplex pvc extrusion to provide a 6mm movement. There is peel off tape to the face of the pvc extrusion. Available Galvanised, Novaplas coated or Stainless Steel. 1Omm, 13mm, 16mm and 19mm thick.
3m long

Metal Lath

A sheet of diamond pattern mesh. Produced for render work and provides a high degree of mechanical bonding with render. Nominal mesh size 9mm X 21mm. Nominal weight 1.15 kg/m².
Available Galvanised, Novaplas coated or Stainless Steel.
Sheet size 2440mm X 690mm

Rib Lath

A sheet of herringbone patterned mesh having a profile between the mesh area. It is self furring in that the ribs space the face of the lath away from the supports and background, leaving a void into which the render can penetrate and form a key. Nominal mesh size 9mm X 21mm. Nominal weight 1.15 kg/m².
Available Galvanised, Novaplas coated or Stainless Steel.
Sheet size 2500mm X 600mm

Render Rib

As Rib Lath but only available galvanised. Suitable for external use and has a heavier gauge than Rib lath. Nominal mesh size 9mm X 21mm. Nominal weight 1.78 kg/m².
Sheet size 2500mm X 600mm

Galvanised Products

Galvanised Products: Galvanised beads are designed for internal use and are manufactured to BS6452 Part 1: 1984. Laths are designed for internal use except Render Rib which has a zinc coating of 450gms/m² manufactured to BS 1369 Part 1: 1987. Novaplas products are as the galvanised products and are then powder coated to give high corrosion resistance. They are designed for external use and are ideally suited for modern renders. Stainless steel products offer a higher specification again and are suitable for exterior application and areas subject to possible salt water exposure.

Bekaert Rendalath is available as a galvanised or stainless steel lath with a building paper / breather membrane attached.  It is suited for timber frame applications and for areas of defective rendering/masonry that have contamination or high/low suction.  There are a range of fixings from nylon plugs to stainless steel staples and screwa with washers depending on the substrate to be lathed.  It is also available with a 60mm phenolic insulation board attached for insulated render applications.  This lath should be finished with K-Rend UF Fibre Base Coat prior to applying the desired drydash, scratch or thin coat render finish.  Available in sheet size 2450 X 650mm.

• Timber Frame Structures
• Steel Frame Structures
• Defective Rendering without the need to remove existing
• Solid backing with a painted surface and no suction properties
• Solid backing with contaminated or varied backgrounds
• New build blockwork with very highllow suction properties
• Masonry with suction but no key

Fixings :  Please ask for details of our fixings